CISCO Wireless Access Point Labs

This is supposed to be a LAB Manual guiding engineers on how to configure the CISCO WAP (Wireless Access Point). Please note that the Labs are supposed to numbered as chapters and every chapter should one level of configurations and all details should be discussed. Less theory and more Lab like outlook is expected, technical terms and some complex standards and protocols are to be defined as footnotes, endnotes, etc.

The configurations on the Lab manual should correspond to a basic network set-up, and every chapter should relate to a step by step increment into provisioning the complete network with the WAP in place.

An example of the outlook is as follows:

Chapter 1: Introduction
Chapter 2: Basic setup
Chapter 3: 
etc, etc,

An example source you can use is as below:

Most important topics discussed in the above link should be a part of the configuration guide.

Please do use other resources as well and the output should be a compiled booklet.

Use the order calculator below and get started! Contact our live support team for any assistance or inquiry.